水保所知识产出(1956---)知识库

为确定硬水滴灌条件下影响灌水器堵塞的主要特征参数，研究 6 种灌水器在硬水滴灌条件下的平均相对流量和
堵塞率的变化规律，通过有序回归方法分析影响灌水器堵塞的特征参数，灌水结束后解剖并观察灌水器内的堵塞情况。
结果表明：硬水滴灌条件下 6 种灌水器的平均相对流量均发生了不同程度的下降，其中灌水器 E1 和 E6 因具有较大的过
流截面尺寸而表现出了较好的抗堵塞性能；SPSS 回归分析显示，显著影响灌水器的抗堵塞性能（P<0.01）的特征参数为
灌水器内过流截面宽 W 和深 H 中的最小者 min（W, H），且灌水器发生堵塞所需要的时间与 min（W, H）成正相关关系；
解剖灌水器发现，堵塞主要发生在灌水器内具有 min（W, H）的截面处。建议硬水滴灌时选择内部过流截面尺寸较大的
灌水器，且灌水器内部应避免易引发固体颗粒沉积附着的截面形状和过流结构。

Emitter clogging is an unavoidable problem when the hard water is used for drip irrigation and it is tightly related to
the form and size of the internal structure. This study was designed to evaluate the performance of 6 types of emitters for drip
irrigation by using ultrapure water and hard water, and main characteristic parameters influencing clogging were determined.
A total of 6 emitters were used for the test. Among them, 3 were non-pressure-compensated, 2 were molded and welded into
dripline wall, and 1 was inserted into thick wall. The other 3 emitters, being inserted into thick wall, were all
pressure-compensated. The hard water was prepared at 500 mg/L using ultrapure water and chemical reagents (CaCl 2 and
NaHCO 3 ). The experiment was carried out at the Irrigation Hydraulics Laboratory of Northwest A&F University, from
October 2014 to January 2015 and from May 2015 to July 2015. A drip irrigation system with cyclic water was built, which
had 12 laterals. Each of these emitters was installed to the 2 of laterals. The drip irrigation system was operated at a regime of
4 h operation a week under a regulated pressure of 100 kPa. The water delivered for each emitter was collected for 10 min to
measure the flow rate of the emitters every other week. The emitter’s average relative flow rate and the emitter clogging ratio
were calculated for 26 weeks to evaluate the emitter performance. The ordinal regression analysis was used to analyze the
influence of characteristic parameters on emitter clogging. The emitter characteristics used included pressure-compensation,
nominal flow rate, water passage length, water inlet fence and the minimum size in the width and depth of flow passage section.
All of the emitters were dissected after all the irrigation events. Photos of the emitter interior structures were taken by a camera
(Canon PowerShot SX500 IS). Then the clogging was assessed by information of sediment deposition inside the emitter. The
results showed that the decline in average relative flow rate was observed with 6 kinds of emitters during the drip irrigation
system running time. Emitter E1 and E6 had the best performance. On the contrary, emitter E4 showed the worst performance.
And emitter E3 was observed a highest emitter clogging ratio after 2 weeks. Ordinal regression analysis showed that the effect
of the minimum size of flow passage section on the emitter anti–clogging ability was statistically significant (P<0.01). And the
anti–clogging ability of emitter had a positive correlation with the minimal size of flow passage section. As the minimal size of
flow passage section increased, the emitter anti–clogging ability was improved. The other emitter characteristics were not
found to be statistically significant (P>0.05). Dissection of emitters revealed that clogged occurred at different areas for
different emitters. E1 was mainly clogged at the head of the labyrinth flow passage. E2 was clogged at the fence where the
water entered from. E3 was mainly clogged at the head of the labyrinth flow passage behind the fence. E4, E5 and E6 were
mainly clogged at a little narrow groove, which was used to achieve a function of pressure compensation. The emitter clogging
of 6 types mainly occurred at the flow passage section with the minimal size. When there was more than 1 area with the
minimal size of flow passage section inside the emitter, clogging had tended to occur at an area that particles was easily to
deposit on. This area was called by “low velocity area”. Thus, choosing emitters with the larger water passage section and
avoiding the flow passage easily causing deposition are important when hard water is used for drip irrigation. These results can
provide important information for understanding emitter clogging mechanism and some suggestions for scientific emitter
selection of hard water irrigation system.